IH-777S-UHR - 21/23oz Ultra Heavy Raw Selvedge Denim Slim Tapered Cut Jeans
-
I would just ask the shop if they have 36 pair with a waist close to 37.0 or just under. My 2 cents is better one inch too loose than one too tight. The waist will stretch back after shrink so i try to make sure the thigh measurements are good as well. Best to email the IH guys though.
-
-
I just realized that the above picture doesn't belong in this thread.
The label actually says 777-UHR, not 777S-UHR.
Thus I posted some pictures over here: https://www.ironheart.co.uk/forum//post/786164 -
@Luijim78 Just keep in mind that these are unsanforised and loomstate, so they will shrink decently upon first soak/wash. The measurements of my 555S-UHR were all around larger than what I normally go for, but after an hourlong very hot soak and gentle agitation, it came out perfect.
Knowing that may help you decide between two sizes depending on the measurements.
-
Hey! Does anyone know if keeping these buttoned up while doing the initial soak/wash minimize waist shrinkage at that point? Thanks!
-
@drewfonse me personally always buttons up. But the UHR needs all the shrink cause it’s part of there process
-
Can't wait to have the tag size 28 in these back in stock!! Steadily waiting for their return!
-
@LittleRockRaw yes I'm also waiting for the same size, I was going to get a 29 but I preferred to wait a bit
-
@Luijim78 Yeah Lui, I am afraid the 29 would end up being a bit large on slender guys like us!
-
This will probably be my next pair, in size 35 or 36, looks like these don't restock very often, (2 years?)
The 555 size 36 in SBG and XHS has been a great fit so far, but I am losing weight and they have both stretched out quicker than expected. The med/high rise is getting pushed down by my beer gut when walking, so maybe a shorter rise is better suited.
Did selfedge ever offer this in a 633? That is another cut I would like to try.
Probably won't get a 888 until l am down to a size 34, to keep the hem/leg proportions I like.
-
@99Tjadams From my understanding the 633 has not been offered in the UHR.
-
@Alex will these be back in stock soon? Want to grab a pair at the party probalby...
-
@Fades-for-future Hopefully, looks like they're last off the press, so should be here soon
-