Random Rants
-
I'm after the 666XhS first run. The measurements on the current run are not the same. The Beatle buster is the opposite of what I want, they have a smaller waist and at least a 9.3in+ leg opening and that's at a 36inseam. By the time you hem them for my short ass you have 9.5-9.7in leg opening, which is enormous. I just don't think IH makes a cut anymore that can fit me how I want. If they made cuts in shorter inseams, like in Japan, they would fit me fine because the cut would be true but not on these 36in+ inseams. Any sort of taper there is gets lost once you hem them to 32ish or shorter.
Tons of other brands fit like fucking gloves, I just don't get it.
Btw, I tried on the original 666xhs run when they came out and they fit like a glove, just didn't have the cash. Also, tried on Zwer's pair, fit like a glove.
So I lay in bed last night thinking about this. Here are the sums:
We measure the knee 13" below the crotch. That leaves 23" to the hem on a 36" inseam
On the majority of our jeans we taper 1/2" from the knee to the cuff
That means the taper is 0.022739 of an inch per inch of inseam
Say we chop 4 inches off, then we lose 0.096857 of an inch in the width
On a hem that originally measured 9.5, it will now measure 9.41" -
That's fucking maddening. Is there a doorman or receptionist at the destination?
-
Finn … I'm guessing it's a guy at the customs.
Had the same issue once ... online tracking says delivered to XXXX .... ran frightened through the whole neighborhood to find somebody with this name ...
.... three days later came the letter with the info to pick it up at customs -
Oh no! Hope everything works out Raf!
-
-
Hahaha i knew its not possible that it get lost
we Swiss are very honest usually 
Extra fit pics Hopp Hopp
fit pics by tomorrow buddy.
for now i'm enjoying everything here in the office
the A-2 fits perfect imo and the LW might need a bit of wear! but i really like the look of an engineer on my feet…let's hope i don't get addicted
-
ok ok ok, might have to turn this b… into an anti rant
one of the new teachers (you know we're refurbishin a school) signed for it...that fekker! ^^
best thing...i now have my AL type A-2 and my Lone Wolf Engineers here with me
Awesome! Glad it all worked out can't wait to see!
-
So I lay in bed last night thinking about this. Here are the sums:
We measure the knee 13" below the crotch. That leaves 23" to the hem on a 36" inseam
On the majority of our jeans we taper 1/2" from the knee to the cuff
That means the taper is 0.022739 of an inch per inch of inseam
Say we chop 4 inches off, then we lose 0.096857 of an inch in the width
On a hem that originally measured 9.5, it will now measure 9.41"Glad I'm not the only one who dreams of numbers and likes them. Really impressive reading this. What I take from that is the taper/fit for Urbs that wasn't working is most realistically likely because they're new?
